OOOoooOOOO, bug eyed monster

Finely putting to use the 25hp Intec that has been setting in that chair for a year

Perty rose colored glow from the heat lamps

Looking towards the stren at temporary bracing for the rear balkhead that warped

Another pic of rear balkhead with temporary braces and permanent gussets to take out the warpage

A pic of the front 3/4 of the hull

Building the air drive deck and lift fan duct

Cutting more foam peices for the lift duct

Well I'll be damned, so that's how you use a square

I mounted the two panels too close to the lift duct, I had to cut them out and move them over so they aligned with the tack strip being as they are also part of the inner tack strip.......DUH.....

I put this message on the bottom of the hull, I was inspired by Jerry Coffman

This is just some grey haired old fart working on the air drive deck for a Sev Scout, jeese, I've got to get some Greeshun formula.

The two inner panels have now been moved in and glassed, I'm now starting to enclose the floation compartments.

I finely have the bottom done except for the splitter plate, I put in a floatation compartment across the rear because of the larger motor, after it was glassed I realized I'll have to cut a hole in it to put in the air drive bolts.......DUH......

I've now flipped the hull over and made the last two panels on each side to finish enclosing the stern......I sure hope nobody takes a tape measure to it, it's solid but not square.